New to flying, just built a quad. Need help with battery issues though.

B

Bizla Cooper

New Member
Hiya, Brand new flyer here. I spent the past couple of weeks building a quad copter, I probably should have started with something more simple, but I enjoy a challenge.
I have now reached a point where google is no longer helping me though :(
Quadcopter flies great, but when the battery gets low, instead of just getting slower and gutless like my RC cars always have, one or more rotors will just stop spinning mid flight. This has caused me to break 5 propellers in the past couple of days. Is there anything I can do to set some sort of auto land or anything a bit safer?
This also leads me to my second question, on my Turnigy i6 TX there is a battery gauge in the top right hand corner, this stays at full until the last moment, but by then it's already too late. Is there anything I can do about this?

I appreciate any help anyone can give, as this is baffling my mind.

The specs of my quad are:

Naze32 funfly (no mag or gps)
12A afroESC 1kh
Multistar Elite 2204-2300KV
Turnigy i6 TX
Turnigy ia6 RX
Turnigy nano-tech 2200mah 3C Lipo
HKing color 250 frame, and bundled PDB
5x3 props.
I'm using Baseflight. Once I get more experience I may eventually use Cleanflight, but only if it's absolutely necessary.
 
Bizla Cooper said:
Quadcopter flies great, but when the battery gets low, instead of just getting slower and gutless like my RC cars always have, one or more rotors will just stop spinning mid flight.
Click to expand...
Get one on of these to plug into the balance port of your battery.
3612100-1.jpg

You get set the voltage that will trigger that alarm buzzer.
  • Alarm set value range: OFF-2.7V-3.8V
Click to expand...
Assuming a 3S battery setting it to 3.5V means the alarm will sound when your pack gets to 10.5V.

Bizla Cooper said:
on my Turnigy i6 TX there is a battery gauge in the top right hand corner
Click to expand...
To actually monitor your pack voltage on your radio's LCD screen you need one of these.
http://www.banggood.com/Flysky-FS-C...n-Module-For-iA6B-iA10-Receiver-p-976303.html

But that will only work with the PPM/IBus RX.
http://www.banggood.com/Flysky-2_4G-6CH-FS-iA6B-Receiver-PPM-Output-With-iBus-Port-p-978603.html
 
Firstly I would like to apologise for the late response, there were some nasty storms last week that knocked out my phone line, and iv'e only just got internet back now. Thank you both for your replies, I'll get a battery gauge ordered :) As for the voltage receiver, I'll stick with what I have for a while before getting that receiver, I Know my TX and RX support PPM but I haven't figured out how to use it yet. Is there any advantage to using PPM when normal wiring works perfectly?
Thanks again, Ryan.
 
You must log in or register to reply here.
Back
Top