Hubsan H108 help needed

M

MikeR

Member
Flying a new H108 in mode two, when I push the aileron to the right, the quad goes left, and vice-versa, no matter how many times I bind/sync and calibrate the gyros.

Assistance would be appreciated : )
 
If your Husban is like my Syma the Chinesse mode 2 is actually mode 1 switch to mode 1 and bet it works fine.
 
Quest said:
If your Husban is like my Syma the Chinesse mode 2 is actually mode 1 switch to mode 1 and bet it works fine.
Click to expand...


Thanks for your response, it's appreciated.

I tried something today - see my next post (reply) please.
 
Last edited:
Here's what I've been doing and what I've observed today:

With TX bound and gyros calibrated, I placed the quad on the floor with it's tail facing me. I apply just enough throttle to observe in which direction the quad turns or tries to lift. After making sure that SETTINGS is adjusted to 50, for each channel, the quad seems to be allright in all directions but forward. When I push the elevator forward, instead of the rear of the quad lifting up to propel the quad forward, the quad rotates on the floor, clockwise. The quad is in mode two while I'm doing this test.

Anybody?????
 
Make sure you are getting it up off the floor a good foot or so quickly the backwash from the rotors can cause the quad to act crazy
 
Quest said:
Make sure you are getting it up off the floor a good foot or so quickly the backwash from the rotors can cause the quad to act crazy
Click to expand...

Good news - I just received word from the seller that they will replace it (the quad) - mission accomplished.

My throttle is up for your kind assistance.
 
Quest said:
Are you sure the props are in their correct locations?
Click to expand...

Yes.

A's in A's, B's in B's, two of each, no more, no less, each letter rotor opposite to it's cousin.

But not to worry, a replacement will be on it's way shortly ; )


Happy elevations
 
You must log in or register to reply here.
Back
Top