Hubsan H108 help needed
- Thread starter MikeR
- Start date
Thanks for your response, it's appreciated.
I tried something today - see my next post (reply) please.
Last edited:
Here's what I've been doing and what I've observed today:
With TX bound and gyros calibrated, I placed the quad on the floor with it's tail facing me. I apply just enough throttle to observe in which direction the quad turns or tries to lift. After making sure that SETTINGS is adjusted to 50, for each channel, the quad seems to be allright in all directions but forward. When I push the elevator forward, instead of the rear of the quad lifting up to propel the quad forward, the quad rotates on the floor, clockwise. The quad is in mode two while I'm doing this test.
Anybody?????
With TX bound and gyros calibrated, I placed the quad on the floor with it's tail facing me. I apply just enough throttle to observe in which direction the quad turns or tries to lift. After making sure that SETTINGS is adjusted to 50, for each channel, the quad seems to be allright in all directions but forward. When I push the elevator forward, instead of the rear of the quad lifting up to propel the quad forward, the quad rotates on the floor, clockwise. The quad is in mode two while I'm doing this test.
Anybody?????
Good news - I just received word from the seller that they will replace it (the quad) - mission accomplished.
My throttle is up for your kind assistance.
Yes.
A's in A's, B's in B's, two of each, no more, no less, each letter rotor opposite to it's cousin.
But not to worry, a replacement will be on it's way shortly ; )
Happy elevations