hi, im like one week into this space, and have already built myself a cheap tyro99 from banggood. it came with an flysky fs-i6 tx and a fs-ia6 rx. the reciever i already understand is some outdated ****, but before i order a new one, i want too see if i at least can fly this until it arrives. my problem is i am not getting any input from any of the sticks in betaflight. it shows the 3d model and all motors are spinning but i cant get it to actually recieve the inputs.
i search all of youtube and google and found out that i have propably just connected via the plastic pin on the fc to SBUS, but i understand i need IBUS. would it work if i resoldered things ? i am leaving some pics, so hopefully someone can tell me where i need to solder what in order to connect it to ibus instead. i am pretty sure this is my last hickup since i feel like everything is working but the reciever.
Thanks in advance, and thanks for letting me be a part of this community
You need to solder the right two jumper pads together, set your uart for serial reciever in the betaflight ports tab, then go to the configuration tab and click serial reciever then click ibus in the dropdown box. Be sure and click save and reboot after every step.
@Dugdog47 i tried soldering the two pads now, but i still wont work. what am i missing ? i tried setting all different uarts to serial rx and my configuration is set to serial-based reciever and ibus. any ideas ?
only thing he really did that i have not already tried was to set ppm to "on" on the transmitter. still same thing. how likely is it that this rx is dead ? the one in the video is even a newer model than this one i got here is without a "b" in the end. looks slightly different. can you tell me if the pin in the rx is positioned as it should? i saw in the video it looked slightly different, but idk.