Search results

  1. M

    dead motor?

    as I heard that 4S ESC is a little close to the edge and the motors are 6S rated I bought that 6S ESC for future upgrades even if probably I'll have to buy a 6S rated FC but in this case I think the motor wire broke and then the ESC burnt, I don't think the bigger ESC would have survived anyway
  2. M

    dead motor?

    I reconnected the broken wire of the motor and now on another esc it works! but if I wire a working motor on the other esc it behaves like in the video, no chance to repair the esc? if i have to replace it, an higher current and higher voltage rated esc would be more durable? or in that case...
  3. M

    dead motor?

    yes I'm trying to learn something on youtube :) in the image you can see the broken wire, I took off half turn of winding because it was too short, but as it is insulated copper wire I don't know how to test the solder joint
  4. M

    dead motor?

    yes I tried but it is the motor, in the long waiting for a new one do you think it is worth to try rewiring it? I soldered the broken one but I don't know if I did it right
  5. M

    dead motor?

    hi all, after a crash (but on the other side) a motor doesn't spin anymore, I checked and there isn't continuity between power in wires and the esc outputs, but also there wasn't continuity between one wire of the motore and the others two so I saw that it broke off on the side of the motor, I...
  6. M

    getting into fpv

    I had a new flywoo, again I flew for a while and then same problem. this time the receiver was isolated and no water on the grass. I must say just before the problem I crashed the antenna from 1m high on concrete but externally I don't see any damage and I flew slowly with 600mw but it is 0 °C...
  7. M

    getting into fpv

    about the battery, the Explorer mounts this stack https://it.banggood.com/16x16mm-Flywoo-Goku-F411-Micro-Stack-F4-V2_1-Flight-Controller-and-BS13A-13A-BL_S-2-4S-4in1-ESC-Flytower-for-FPV-Racing-Drone-p-1615281.html the ESC has 15A burst current and the FC has 2A BEC, considering a little...
  8. M

    getting into fpv

    let's see if banggood replaces it to me, sometimes I also noticed the screenshot attached, as if the camera wasn't working
  9. M

    getting into fpv

    I'm sorry for that I updated the links you can watch the videos now As you will see the OSD is present but the signal is weak so I think the problem is in the VTX but don't know how to diagnose
  10. M

    getting into fpv

    I definitely have a problem with the video signal, you can see the difference between 1st and 2nd video, I don't remember crashes in between but since the receiver has diversity, I tried all the antennas combinations and the OSD disappears along with the video I think the problem could be in the...
  11. M

    getting into fpv

    Yes of course 2 differenti issues about the video even if I flown slow the cold should have helped not damaging the VTX, which I tried at home and works about the control I bought TX and RX together so the tuning should match, unfortunately FlySky limits the choice but let's see if the new...
  12. M

    getting into fpv

    No I meant on the video receiver, on the VTX I have the Flywoo antenna which is for long range, today I tried with 2 Eachine K-Loverleaves on the ROTG02 but even outside the building I couldn't get a reliable signal, it is surrounded by portcullis and so maybe flying close to it 600mW works...
  13. M

    getting into fpv

    about the FPV system, now I'm flying with the ROTG02 with 1 Eachine dipole and 1 Eachine K-Loverleaves antennas and it is not bad but because of rain I'm flying in an empty covered market and sometimes I can't get a stable signal or I get a grey screen, maybe there is interference, anyway I'll...
  14. M

    getting into fpv

    you are right, the RSSI channel is AUX 8 that doesn't match any input on my TX and just stays in the middle (51%), I'll wire it on the new receiver, as maybe the weak link in the chain is TX - RX rather than VTX - OTG, I'll test it with the drone disarmed and also I'd test GPS hold as failsafe.
  15. M

    getting into fpv

    yes I don't know where that value comes from, bidirectional DShot is disabled in Betaflight, what about RSSI and link values? in fact to see below I had to pitch to the maximum
  16. M

    getting into fpv

    yes I think angle mode is ok for cinematic, even the DJIs don't fly acro, but to not get into bad habits I'll continue to train it on the SIM and maybe I'll try acro trainer. once succeded to look at the phone instead of the drone FPV is even easier than LOS, delay is not a problem but even with...
  17. M

    getting into fpv

    despite is dark, cold, and snowy, I'm flying at least a battery a day plus Liftoff at night. I broke one of the antennas of the receiver so I ordered the FS-X14S that seems to be the best FlySky now and I broke the beeper but still blinks. now I can stay in flight for the whole battery life...
  18. M

    getting into fpv

    Yes I think flying an unrealistic SIM is counterproductive
  19. M

    getting into fpv

    ops I didn't see other replies, I'll take a look to skyzone too. for the cruise flights I intend to do latency shouldn't be a problem, of course for racing I'd go for a full analog system. I signed up on velocidrone but seems there is not a free version :(
  20. M

    getting into fpv

    Yes the idea is that, I bought the Eachine ROTG02 and the app seems reliable, not the dvr but I can use the screen recorder of the smartphone, latency is not much more than that of digital fpv systems. the EV100 should be the Eachine entry level goggles you said for about 100$ but I'd like to...
Top