Search results

It's a nice frame, but not much room. The tbs discovery frame or clones have more room and are good too. The xj470 frame will support much larger motors, so it is an option for your build too. I contemplated installing the e600 (3508 415kv with 12 inch props), but decided I wanted speed instead...

Ordered a new set of motor mounts. Lets see how these do. Not the best looking, but I did not want plastic, or the wide tarot mounts.

How long have you been doing photography with drones? Since 2015 How many drones do you own? 5 Currently, but can change at any time How many controllers do you own? 5 What is your preferred controller? Why? Taranis - Programmable, open source, and well built What is the most difficult thing...

Nice looking hex, and co pilot :D

How to calibrate the escs. Throttle stick up to 100%, power on the esc, and then lower the throttle stick to 0%. Should make a couple beeps signifying the calibration. *** remove props before calibration***

Nice! I added the dbs maxrange on mine, and have had mine out over 4 miles, and sweated the last 1000ft back due to battery level.

The frame has a high plate that does allow a from mounted gimbal that will keep the props out of view. It came with all of the mounting hardware too, but I do not have a gimbal for it yet.

Is your radio binded to the rx?

Have you calibrated, and setup the radio to the controller in the assistant software?

16mm, but I don't want the plastic tarot ones, or the super wide ones.

Gains are too high. I brought them down, but it was not enough. You cannot buy those mounts without purchasing the entire frame. (boo) Time to find some replacements.

First flight did not go so well :/

http://www.theverge.com/circuitbreaker/2016/8/31/12716212/garmin-virb-ultra-30-action-cam-4k-stabilization-voice

Welcome aboard! Just know that once you join this hobby, you can never leave :D

More additions.. Time to heat up the solder :)

It should bring the shutter speed down, and your videos should look smooth once you add.

Looks good. Are you using an ND filter? It looked a little jumpy at times.

I started my build thread this weekend :cool:

I would fly a 4s minimum with 900 kv max on a 600mm. (flight time will increase with lower kv spinning larger props) I flew 415kv with a 6s setup on my 680 hex.