Search results

Frustrating part was that it never popped, everything powered up fine, three times.

Forgive my ignorance. What should happen is there was an issue when using it?

:( Didn't know but I do now. Gave it a poor review, for what it's worth. Got a better source?

Ummm....well....It wouldn’t be inaccurate to assume that I couldn’t exactly not say that it is or isn’t almost partially incorrect. Oh, on the contrary. I'm possibly more or less not definitely rejecting the idea that in no way with any amount of uncertainty that I undeniably...

SUCCESS!!!! Well, sort of. Turns out the video issue was due to a damaged connector on the antenna.

I am going to toss mine, the fire happened after I went full power. I learned a valuable lesson with it though, I check my connections many times over, go out to the garage to test, have nothing else on the frame aside from the esc board/motors and plug in just enough for a solid connection so...

I have one and all went well with it the couple of timesi plugged in with it

Enters with a Johnny Cash song in the background. Frame: Armattan Gecko 3" Stack: DYS Mini stack set Mini F4 with F18A 4-in-1 esc Motors: Rotor Riot Hypetrain Brat 1407 4140kv VTX: RDQ Mach 2 with IFlight pagoda Camera: Foxeer Arrow Pro 2.1mm Props: HQ T3x3x3 PC DP Durable Prop

Sounds about right. The last time i tried to run my camera off of a 5v it didnt power up until i connected it to the vbat pad on another fc. So a line from the camera and voltage sensor from the arrow to the battery.

Ok, round two in the ratkwad build. New stack, new motors, success with the first powering of the esc board. So I am on to the next steps, rx, tx and camera. Camera: Foxeer Arrow Pro requires 7v+. Can I solder the positive wire to a V+ pad on the sides? Smart Audio: where do I connect...

The really frustrating part of this stack (HGLRC XJB F438) was that when I first got it from RDQ and wired up all but the motors, I found that the VTX was DOA. I contacted RDQ about it and they promptly refunded me for the whole stack due to not having any more in stock and told me to keep the...

My first build. Got everything wired up, plugged in a smoke stopper and then the battery… All powered up, nothing went poof. Plugged in straight to the battery, rear motors smoked. Unplugged, found the bolts I used were too long and arced the coils, switched them out and plugged in again…

Did another brain transplant for the BabyHawk R brain into a 3" alien style frame and replaced the stock VTX with an RDQ Mach 2. This is the maiden flight since the operation and also the first flight with my new FrSky X-Lite. I was testing both the range at 25mW and an AXII stubby I put on my...

Yup, going to have to buy a bigger house so I can whoop like that!

As am I! Even the props did pretty well, some damage, chipped corners but still flyable. I didn't show all the crashes I had, just the more memorable ones. This was the only real damage it took.

So a few weeks ago I managed to break my Firefly in the most unusual of ways. I hit something that drove the micro USB plug off the board so I lost the ability to charge the battery or access the videos from the sd card without removing it. I went to Banggood and was planning to pick up a new...

I honestly could not tell you which is best. My first micros were 8.5mm, so a completely different battery than what this uses.