Recent content by MikeFletch

Thanks for the reply and sorry for the late response. I don't believe any propellers are rotating the wrong way as I've checked diagrams and run the props at low speeds to verify the orientation. As for the signals this all sounds a little confusing for me but I do know that the channels are...

Hey thanks for the reply, and sorry for the very late response. The naze is currently running on cleanflight I believe and I've also tried multiple other softwares such as betaflight. All have the same outcome.

So I started this build a long time ago and have only flown the thing for about 30 mins. I seem to have a configuration which does not work. I have the following: Naze32 Afroflight flight controller, 6ch tx, 4 in 1 20A ESC with built in PDB and 4x Multistar Elite 2204-2300KV Multi-Rotor Motor...

So using the BLHeli Configurator, ive read all four of my ESCs, then clicked flash all, at this point, a tab opens saying target. I know ive got Afro 20A but do not know what mode or version to flash to the ESCs.

thanks for the reply mozquito. im not sure how to calibrate Multishots and DSHOT will not work - the motors just carry on beeping. Not sure how to use BLHeli either so im a bit stuck here. Thanks for your help though :)

I set up the board with the DSHOT600 ESC protocol but when I start the quad up the motors still beep as if they need to be calibrated. Pls help

Hi thanks so much for the response, looking on Cleanflight, i can see that there are multiple DSHOTs to choose from, i was using PWM before as that is what my receiver uses. How do i know which one to choose from, there is 150, 300, 600 and 1200. Thanks :)

Sorry to post in such a short time but these ESCs are quite irritating. To calibrate these ESCs I first used CleanFlight, setting throttle to max, hear the tune, then to min throttle. Using the software, I increase throttle to see if they're calibrated properly, I'm sure they are. So I plug the...

Thank you both so much, using what you both sent me, i was able to get some input from the receiver. Just needed to plug all the Aux's in thanks guys :)

So i'm totally new to drone building, started around 2 years ago but never got the thing finished. Right now, I am trying to set up the receiver, which is a FlySky F6-T6. Following the documentation with the board, i connected it to the receiver using the flex cable. When I power up the board...