Help setting up receiver to SP Racing F3

Discussion in 'First Build' started by MikeFletch, Jun 12, 2018 at 6:30 PM.

  1. MikeFletch

    MikeFletch Member

    So i'm totally new to drone building, started around 2 years ago but never got the thing finished. Right now, I am trying to set up the receiver, which is a FlySky F6-T6. Following the documentation with the board, i connected it to the receiver using the flex cable. When I power up the board and have it plugged in with USB with CleanFlight open, i receive no input from the receiver, all values stay static. The serial link status also starts flashing, im not sure what this means.
    Any help would be appreciated
    Thanks :)
     
  2. Jackson

    Jackson USA member at large



    I think your RX will only do PWM.
     
  3. mozquito1

    mozquito1 Well-Known Member

    Your modes need to be setup along with Aux channels (Arm & modes switch) before input is received in the rx tab.
    Also pwm selected in rx type on configuration tab.
    I had an fsi6 that does pwm, ppm, ibus.
    I'm not sure about the T6. What cables came with your rx. 8 x 6 servo plug adapter. If so it's pwm. 1 wire for each channel with +-
     
  4. MikeFletch

    MikeFletch Member

    Thank you both so much, using what you both sent me, i was able to get some input from the receiver. Just needed to plug all the Aux's in thanks guys :)
     
  5. mozquito1

    mozquito1 Well-Known Member

Share This Page