Recent content by David Whitehurst

RENOV8R: We're getting lots of wind and rain. It's just started here. We have a generator and I have an FCC license, but I would sympathize with anyone getting any of my morse code, lol. My neighbors have chain saws and we have lots of pine trees. We're prepared and I'm looking forward for it...

Hi, I'm David Whitehurst and I live in Fuquay Varina, NC near Raleigh. I got an ANET A8 3d printer and found the Peon230 racing FPV. I'm hooked! I'm still building and I've gotten to the point of TX/RX pairing and using OpenPilot ground control setup. Something is wrong currently because after...

Mozquito1: Thanks! I didn't know that the FPV camera audio could go into the CC3D. I'll do some more study. I plugged in my ESC (I'll call them servo/throttle) leads into 1,2,3, and 4 in succession. I found a single black plug on an extra wire that was red and I soldered it to my 5V regulated...

I have a very small FrSky micro receiver and it has gnd, 5v, sbus, cppm, and s port. The receiver has a cable and colored wires. The flight controller cc3d has a receiver cable too and more wires. Can I assumably match the wire colors and just cap with heat shrink the wires I don't use? My...