Why do I do it.

[mozquito1]

All was going OK, no problems till I decided to update my fsi6 to the 10 channel mod. I got it to update no problem. And the bind takes but no response in cleanflight. So I factory reset the fsi6 & bound the rx but still the same. I haven't even unplugged any wires except the battery & the bind plug, I use ppm so the one wire is power. So if anyone can save me any time with a few options I'm all ears. Everytime I take time off work to spend some serious time flying I hit a problem. I have tried a CF restore default. The tx is bound to the rx, it is showing up, just no response in rx tab or modes in CF.

 

[mozquito1]

I thought a factory reset restored the original firmware but no. I had to reload it. & now all is OK. So now I have arm on the stick & G tune on SWD then I will put arm back on SWD in the field after auto tune. No need for 10 channels, just being greedy.