Where to connect battery to PDB?

T

TCSAlone

New Member
Hello friends,

Very new to the hobby, building a kit. I have a Foxeer PDB that I need to connect to a battery via an xt60 connector. Most PDB's I've seen have specific pads to solder this connection to, but this board does not?

I also cant find any documentation on the mfgr's site.

Can I just use any of the larger + and - pads, and this will power the whole board?

Thanks in advance!
 

Attachments

  • foxeer_PDB.jpg
    foxeer_PDB.jpg
    50.3 KB · Views: 7
Yah probe around with multimeter in continuity mode or ohm-meter mode and can see what is connected before soldering things too.

Generally good practice to test after soldering things too and before powering up (and/or use a smoke stopper)
 
Back
Top