Mac McCracken
New Member
New to quads, new member
Burned out motor
Twist, solder, heat shrink failed motor. Then it seemed like new motor was stronger,(tipped away from new motor) correctly soldered other 3 in as the were "upgraded motors". Now quad just blinks fast!
Batteries in quad and tx are good. I don't see any problems on circuit board. Was using borrowed "power probe" butane soldering iron. Didn't realize the "exhaust heat". It melted and deformed the plastic on a few spots of body base. Bought new black body and swapped everything over. No change. It just blinks fast like low battery.
I have tried everything, it just blinks fast and won't "bind"?
Please help
Burned out motor
Twist, solder, heat shrink failed motor. Then it seemed like new motor was stronger,(tipped away from new motor) correctly soldered other 3 in as the were "upgraded motors". Now quad just blinks fast!
Batteries in quad and tx are good. I don't see any problems on circuit board. Was using borrowed "power probe" butane soldering iron. Didn't realize the "exhaust heat". It melted and deformed the plastic on a few spots of body base. Bought new black body and swapped everything over. No change. It just blinks fast like low battery.
I have tried everything, it just blinks fast and won't "bind"?
Please help
Last edited:
