Spektrum sattelite and cleanflight

R

Renghor

Member
Hi!
I'm at the end of my QAV-R build with a LUX FC and a SRX spektrum satellite but I have a final issue before making this beast fly.

In fact in cleanflight on the receiver tab all my channels are illogically reversed. As an example moving the roll stick to the left on my DX6i increase the yaw and to the right it decrease the pitch or moving the yaw stick to the left do nothing but to the right it decrease the AUX3… o_O

I have the exact same problem with another spektrum satellite but my DX6i works fine on AR610 receiver I have on another quad. So apparently my RX and my TX are both fine...

I would really appreciate some help please! ;)
 
Go into the receiver tab of your Cleanflight - click on reverse box of channels that need to be reversed. Boom
 
Thanks in fact the channels can be reversed. I've found that when you change the mapping (TAER1234) in the CLI you can exchange the channel but it seems that I have to change "half-channels".

As an exemple when I push my throttle stick for the first half it increases the throttle (from 1306 to 1960 which are strange values...) and then the second half makes the AUX3 goes from 1050 to 1700...
So when I change the mapping I can only make half channels match but there will always be the other half wrong. o_O
 
I just did it but it don't change anything. This TX is perfectly working with another receiver so I think the issue come from cleanflight but I don't know how to change these channels ranges.
It's like if every channel is divided in two parts affected to other wrong half channels :eek:
 
There's 2 types of stick calibration. One in CF and one for your transmitter. You may have to do a search on how to calibrate yout DX6i
 
I did a search on how to calibrate the DX6i and I did it on the TX but I can't find anything about a stick calibration in Cleanflight but that would be very helpfull!
Could you please explain how I can do that?
 
Renghor said:
I did a search on how to calibrate the DX6i and I did it on the TX but I can't find anything about a stick calibration in Cleanflight but that would be very helpfull!
Could you please explain how I can do that?
Click to expand...
Sorry, I was thinking of another FC. In Cleanflight, go in receiver tab and just adjust the endpoints in your radio so that the figures are 2000 at the high end and 1000 at the low end. Mid should remain at 1500
 
You must log in or register to reply here.
Back
Top