Spectrum DX6 mixing help needed

Sp00kie13

Sp00kie13

Member
hi guys

After a bit of help with the mixing on my dx6 tx. I've built a zmr250 with a full naze32 rev6 board, but want to set up things like angle, baro etc. Through clean flight, but as I only have 2 aux channels I'm stuck on how I can do this, I have seen a post that recommends using mixing, but no idea how to do this, or how to implement it.

Can someone help?
 
Will the same work on the newer dx6 (black) as with the dx6i as looking through the tutorials, I have noticed some differences
 
Ok, Ive had a look at it and it seams quite easy and most of the DX6i settings can be transfered to the DX6.

Are there any particular functions that would work well together? I've managed to get the equivalent of 2, 3 position switches
 
Last edited:
That is the same with Turnigy Er9x. I used it to set up 6 flight modes on my quadcopter.
 
You must log in or register to reply here.
Back
Top