sky drone pro v2

dacloudster

dacloudster

New Member
Hi All!
I am new here ok so i have a sky drone pro v2 that i got for xmas. because i want to start flying drone/quadcopters. I love it. but i have a problem.

So first one of the motors on my drone had been damaged. somehow, even thou it is in a small protective case. Which caused the propeller to not spin. so i opened it up and the cap on the motor had popped out slightly so i popped it back in. But then the wire came of so i soldered it back on then the other one came of same with that one soldered it on i checked the motor on the opposite side. And it seems to be correct. but now when i start it up, it is like that one prop that i had fixed is not getting enough lift, but seems to be spining pretty fast And the drone will not life up. it just tips toward the side the propeller that had been fixed.

Any ideas. And thanks

Also anyone know where i can get some spare motors for the Sky Drone pro v2
 
Make sure you did't put the prop on upside down, any writting on the prop shoul be facing up, also if you had more tan 1 prop off at the same time make sure you put them back on in there correct locations.
 
I have the exact problem but am yet to open it up.. mine takes off to about 2" and then travels backwards and flips over! I need to get it sorted as my wife bought it as a start.. she will never let me get a phantom if I break this one so quickly
 
Quest said:
Make sure you did't put the prop on upside down, any writing on the prop should be facing up, also if you had more then 1 prop off at the same time make sure you put them back on in there correct locations.
Click to expand...
It is pretty much impossible to put a prop on upside down, how would one even do that unless they have had too much to drink lol. they are definitely on correctly, They have the letter A & B on the props and below the shaft where the motor rests Like A is on A , and B is on B , and they all spin the way they are suppose to spin

Thanks
 
The props really are difficult to put on upside down, they don't have a large enough hole on the top to get confused by and the screw to hold onto the prop shaft is only on the correct side.
IMG_1854.JPG IMG_1853.JPG
 
Back
Top