S. O. S.

Timothy Paskievitch

Timothy Paskievitch

Member
I have the eachine 250 and I used open pilot 15.02.02 to erase and upgrade my flight controller with the set up wizard. Went through all the steps and now my drone won't respond to my radio. It worked while plugged into my laptop amd I hit save before unplugging but when I tried to fly the next day there was NOTHING going on. Can anyone please tell me what I need to do to get back flying! Ive only had it for about 3 weeks.
 
So if I understand correctly, now that you've done the firmware upgrade it responds to your radio when you're connected to the Openpilot software assistant, just not when you disconnect it?
 
RENOV8R said:
So if I understand correctly, now that you've done the firmware upgrade it responds to your radio when you're connected to the Openpilot software assistant, just not when you disconnect it?
Click to expand...
Correct. It doesn't do anything when I try to fly now that ive done the open pilot erase and upgrade. Have you had this problem or know what I can do to get back in the air? It only responds while plugged in. I followed all the prompts and steps
 
It sounds like it's just not arming. Is your mincommand set lower than your minthrottle? Also, what flight controller do you have?
 
i think you just need to rebind your transmitter did the eachine come ready to fly or did you bind it yourself ?
 
Ready to fly. And I have the one that came withy ho drone. It was fine but I crashed and after that when I would take off it rotated CCW on its own so I tried the wizard to see if thay would maybe correct it but now I'm having this problem.
 
Did you run through the Transmitter Setup Wizard?

maxresdefault.jpg
 
Yes. I did all that also and it was responsive on my laptop but when I tried to fly the next day there was no response between transmitter and the drone
 
You must log in or register to reply here.
Back
Top