Reciever troubles

I just checked what you think I said
"format tx" I did not my friend.
If I did please quote it.
I said reset the board in settings tab
betaflight-Setup-configurator-setup-1024x609.jpg
Second one down reset settings.
 
Eduardo said:
I dont thing its the rx, because it already work a while ago. Maybe its the naze32 but It might be some kind of settings
Click to expand...
Reset the board
See if all the channels show up again.

The only other thing to cancel a bad rx is to plug each individual channel into the pin that is working on the flight controller.
The one that is picking up the Aux channel.
Get me?
If it picks up each channel in turn then it's the flight control. And 5 pins are bust.

Cheap shitty nazes.
 
All the above is all I got for this problem.

3 for the flip
& a board reset
3 for the rx problem &
Individually check each rx channel on the pin that is picking something up on the fcb.
 
The real big problem now is when I open betaflight at the page reciever Roll, Pitch, yaw and Acelera just doesnt respond to my comands on the transmitter. But the aux signals works perfecly fine. What should I do? Im using naze32,Fsia6 and AFHDS2A as reciever
 
He said in his 1st post the calibration did not fix the values. It wouldn't. That is for esc's.
The board reset MAY fix this.
My build was A OK but it fixed my problem, whatever it was.
Just one of them things.
If it flipped it was all there.
Except props on wrong way
Or
ESC's on wrong motor pins
Or
It just needed a board reset for some mad reason.

It flipped & now he not seeing 5 channels
So even with a board reset he can't check if the values are correct.

I don't think it's the rx myself as my ia6 had about 80 crashes I have de pinned it & been in & out of so many frames. They are tanks.
But the naze fcb is definitely not.

My advice, stay away from naze

Sorry its 3am here I'm off to bed guy's
I can't explain it any other ways.
 
So they are there but not working.
You didn't say that.
Then it's back to

AETR1234

Config tab, receiver type set to RX pwm
Save it. Disconnect then connect & check it saved as rx pwm.
Then goto receiver tab & check it says AETR
At the top. Receiver-1024x542.jpg
Like this or jut AETR.
This is the setup for mode2 flysky tx
My setting.
 
You could try the transmitter menu to see if ppm is turned off on rx setup.
But Aux is working so shouldn't really be that. Was the tx rx bound when you got it.
 
Eduardo said:
So I formatted the transmitter but now after the bind process the only channels that the betaflight perceives on the page are the throttle, aux 1 and aux 2. Plz Im desperate help
Click to expand...
Do you mean format the flight control.
If this has happened after the flip then it looks like the board is damaged, If its not picking channels up.
Where the values OK before you tried it.
eg min 1000 mid 1500.
All the answers are above anyway.
Good luck.
 
Back
Top