Radiolink AT10

D

Drone learner2

Member
I have a quadcopter i am.building just wanted to know if my at10 will work reason for my asking is this is the first gen of the at10 there is no micro usb on bottom right of controller but a power supply looking plug with a pin in the middle. The setting only have helicopter areo and glider but under the helicopter there is a set uo called hex4 wud this work for my quad layout?
 
Hi on heli mode it needs to be H1 or single servo , you should be able to set up on plane mode just make sure any mixing is disabled
 
Hi sorry late reply H1 or aero is only in transmitter setting there should be no mixing in any set up in transmitter so H1 is single servo with no mixing aero set up your need to make sure there no mixing like V tail etc
The + or x quad is all done in the FCB of the quad
The transmitter setting is as basic as you can get all the hard work is done by the FCB
 
holtneil said:
Hi sorry late reply H1 or aero is only in transmitter setting there should be no mixing in any set up in transmitter so H1 is single servo with no mixing aero set up your need to make sure there no mixing like V tail etc
The + or x quad is all done in the FCB of the quad
The transmitter setting is as basic as you can get all the hard work is done by the FCB
Click to expand...
Ok thank you for your help i appreciate it alot
 
You must log in or register to reply here.
Back
Top