I have 4 emax motors model 2213 with 4 20A blheli escs connected to an i86 flight controller plugged in on the left side of the chip. The chip itself is set in X-Quad conf. I have rudder throttle alieron and elevator cords on the right side of the chip connected to my reciever. My reciever and remote are hobbykings make. Finally the escs are powered by a 3cell lipo battery (brand tipple). When i fire it up a blue light stays on which means it is ready for flight and unlocked but when i move the controls nothing happens. Any suggestions or help would be amazing. Thanks!
Quadcopter build problem
- Thread starter bhob12
- Start date
I programmed the ESCS, I'm not sure if that means the same thing as calibrate. And i have no clue what arming the controller means. Please explain! It might help! I feel like i may have not put the servo leads in the correct slots on my reciever... I'm just not sure. Thank you so much for replying.
Jackson
USA member at large
What an odd ball FCB you chose. No real info out there.
http://www.hobbyking.com/hobbyking/store/uploads/406500306X7478X32.pdf
http://www.hobbyking.com/hobbyking/store/uploads/406500306X7478X32.pdf
DJIdude
Drone-lover, DIY builder, and huge DJI fan
Yeah, there's about as little info on the i86 FCB as there is support for the old x86 CPUs.
(Couldn't resist)