Quadcopter and Controller Not Communicating

K

kgray9

New Member
Hi all!

I am new to this forum so please be patient with me.

I just got a quadcopter from an uncle with a controller and FPV goggles. He was into racing drones but hasn’t used it since 2016. The last time he used it, it crashed and the video antenna snapped. He already ordered a new one though and just hadn’t put it on. I put the new antenna on but the drone itself is not working. I tried out the FPV goggles, and the video is working on them. I just can’t get the controller to communicate with the drone.

The controller is a Turnigy Evolution. The receiver is a FS-IA6C. I have the SBUS on the receiver attached to the RX on UART3 on the SPRacingProF3. In Cleanflight under “Ports", I turned on the UART3 toggle for “Serial RX”. Under “Configuration”/“Receiver", I have set the “Receiver Mode” as “Serial-based receiver (SPEKSAT, SBUS, SUMD)” and the “Serial Receiver Provider” as “SBUS”.


Some photos of the receiver and connections:

IMG_0142.jpegIMG_0144.jpegIMG_0143.jpeg


Some photos of the software setup:

Screen Shot 2021-11-16 at 5.45.03 PM.pngScreen Shot 2021-11-16 at 5.44.44 PM.png


I did update the firmware on the drone, but not on the controller yet.

I have been troubleshooting this for several days and am getting nowhere.
Any tips would be extremely appreciated.
 
Launchpad

Launchpad

Well-Known Member
I think if you change to i.bus receiver mode in cleanflight you will be okay.
The radio also has the option to output i.bus, or s.bus.
I would stick with i.bus though.
 
K

kgray9

New Member
Badfish said:
I think if you change to i.bus receiver mode in cleanflight you will be okay.
The radio also has the option to output i.bus, or s.bus.
I would stick with i.bus though.
Click to expand...
I did try changing it to ibus in cleanflight but still no luck. How do you change the controller to ibus?

Also, I have gotten the controller and receiver to pair every time. There is just no data being received on the SPRacingF3. I checked all the wiring several times and everything is good.
 
You must log in or register to reply here.
Top