QRX350

D

David c

Member
Hi I have a Walkera QRX350 this is not the Pro version. I have also purchased a Gimbal G-2D seperatly and I am having problems. As it is not the pro it did not come with a lead from the receiver to connect to the Gimbal, I have connected the wire to the receiver at the AUX 2 connector on the Quad's receiver.I have also gone in to the settings on the Devo 7 transmitter and activated the Aux 2 setting in the transmitter. The Devo 7 will not talk to the gimbal can anyone help me with the correct connections to the Gimbal. Many thanks to anyone willing to help me
 
If it will not work off aux may be look into getting a gimbal gyro , this will control just the gimbal all you need is power to it
 
holtneil said:
If it will not work off aux may be look into getting a gimbal gyro , this will control just the gimbal all you need is power to it
Click to expand...
The Gimbal that I have is the Walkera G-2D that has its own Gyro. When I connect the power lead to it , it does self level but what I require it to do is remotely tilt via the turning of the knob on the DEVO 7
 
Hi I am a bit lost the signal wire from aux on receiver should go to the gimbal pan or tilt ,I think your only be able to go tilt or pan not both as your only using one axis from the receiver
I just looked through the manual it says that if your using the knob to adjust there is a switch on the side of the gyro this must be in position 1
http://www.walkera.com/productinformation/G-2D/G-2D Manual english.pdf
 
Last edited:
You must log in or register to reply here.
Back
Top