QAV 250 build help please

R

RcMark

Active Member
Hi all,

I have built a QAV250 Quadcopter and I have come to the part were openpilot is needed to program it, however when it asks to plug the battery in I do and I get loads of beeping and the motors only twitch they dont spin, I checked through everything de-soldered cut the wire to get fresh wire and re-soldered again perfectly, but the same issue, I go to the next part of openpilot were I spin the motors but none of the spin.. Im using cc3d atom (mini) flight controller and flysky fs-t6 transmitter..
Pleaset please please help I have no idea what to do now.
 
RcMark said:
I have built a QAV250 Quadcopter and I have come to the part were openpilot is needed to program it,
Click to expand...
Have you run through the Transmitter set up wizard? That to me is a very important first step. You have to make sure the sticks are responding correctly. You probably have to reverse at least one channel. And with the FlySky by default AUX1 (ch 5) and AUX2 (ch 6) are assigned to the pots. What did you use for flight modes?
 
Jackson said:
Have you run through the Transmitter set up wizard? That to me is a very important first step. You have to make sure the sticks are responding correctly. You probably have to reverse at least one channel. And with the FlySky by default AUX1 (ch 5) and AUX2 (ch 6) are assigned to the pots. What did you use for flight modes?
Click to expand...

With the transmitter I put plug with the red white & black wires into bat, then I went in order of the wires into 1, 2, 3and so on, i dont know which colour is for which number
 
RcMark said:
With the transmitter I put plug with the red white & black wires into bat, then I went in order of the wires into 1, 2, 3and so on, i dont know which colour is for which number
Click to expand...
Are you talking about this connector labeled #1?
SKU153980-1.jpg

If so that is for the Throttle, which for your RX needs to be plugged into channel #3.
 
Jackson said:
Are you talking about this connector labeled #1?
SKU153980-1.jpg

If so that is for the Throttle, which for your RX needs to be plugged into channel #3.
Click to expand...


Ok so the black, red and white wire into 3, the next wire is blue then yellow then green then yellow then black, which numbers do the rest of the wires go in?
 
You must log in or register to reply here.
Back
Top