Protocol Dronium III

L

Lmckillo

New Member
Good Day .
I have a older Protocol Dronium III . The drone turns on , the control turns on and syncs to the drone . Does what it’s supposed to , move the power stick up then down , two beeps and it’s connected. I then calibrate the drone , lights flash fast then stop when it calibrated.
When I try to start the motors on the drone there is absolutely no power to the motors . Fresh batteries in both the drone and the controller .
Any ideas why there would be no power to the drones motors ?

Thanks
 
Hi you need to arm the motors most drones need both sticks down and away from each other to arm and same to disarm
 
You must log in or register to reply here.
Back
Top