Picking out the right matching parts

[Pitj3]

Hey everyone, first post on this forum.

A while back I was building a quad from scratch and ordered the majority of the parts online. So I've got a F450 frame
4 1100KV motors (2 CW, 2 CCW of course),
4 generic simonK ESC's (20A)
KK HC flight controller 2.15

I was using an old transmitter and receiver which I now want to replace.

I was looking at this vid: youtube: UAVfutures (how to build a pro FPV racing drone for only 99$)

Looking to add a camera to this quad, a power distributor and a new receiver + transmitter.

Don't want to spend too much on the receiver + transmitter, and I know the power distributor and camera aren't too expensive too (looking at the video).

I might be looking into replacing the KK HC with a Naze32 full,

I hope some of you guys can help me out find the correct missing parts (including correct props) to make this drone complete.

Pit

 

[Jackson]

Looking to add a camera to this quad,

For FPV?

 

[Pitj3]

For FPV?

Yes sorry, should've mentioned this, not for recording high quality video (might add this later on another drone (or this one if it supports)).
But for now just a camera for FPV

 

[Jackson]

Maybe one of the AIOs.
http://www.banggood.com/Aomway-HB25...e-Camera-4_8V-24V-p-1069179.html?rmmds=search

This is interesting as it has a built in DVR (insert a card and you can record.)
http://www.banggood.com/Eachine-DVR...4-Cmos-FPV-Camera-p-1117419.html?rmmds=search

Lotsa choices and reviews to read. DOn't know where you live, 200mv is a plus (more range.)
http://www.banggood.com/search/aio-fpv.html

For TX/RX the latest i6X packs a wallop for the $.
http://www.banggood.com/Flysky-FS-i...6B-i-BUS-Receiver-p-1090406.html?rmmds=search

 

[Pitj3]

Thanks for those links! I've never seen an i-BUS receiver before, how would I go about hooking that up to say a KK HC or Naze32?

 

[holtneil]

Hi Pitj3 the KK will run off a sat receiver so no need for a full receiver if you go to a spektrum transmitter but as Jackson said the link is a really good transmitter for its price you wont beat it for that

 

[Jackson]

I've never seen an i-BUS receiver before, how would I go about hooking that up to say a KK HC or Naze32?

Channels: 6(PWM), 8(PPM), 18(i-BUS)

You can use standard PWM with a dedicated wire for each channel, or PPM which will use just one 3wire cable to the KK.

Many of the newer boards like the Naze/F3 etc. will directly accept IBus, when used with the i6X TX that can also be changed to SBus.