Noob help please.

S

Spooky

New Member
Hi, i bought a Motorwhoop 90... tho messed up a bit as i opted for a no receiver version thinking that as it already had a vista , that it would be auto set up for it and ready to go as i want to use my dji goggles and controller.
It arrived with a plug for a receiver but not connected.. https://imageshack.com/i/poohb24Qj . The flight controller is a HGLRC zeus AIO 13 and after looking at the manual ( https://www.manualslib.com/manual/2193313/Hglrc-Zeus13-Aio.html?page=4#manual ) .... i cannot figure how to wire this up as i dont see an option on the controller for the sbus ... or am i totally thinking wrong here.? I havent built any quads myself but i can solder electronics ok, just need a bit of advice on what goes where.. would really appreciate any advice thanks.

​

 
I saw that with other types of recievers but just needed a push i guess as i wasnt that confident being the first time so thanks.
I have wired sbus to rx1 .. blanked the 5 volt cable as vista already powered and connected the second ground ... seems all good in betaflight ...shoved a battery on it and all good...tho found out my charger will charge about 10 different types of batteries but not a xt30 so have to wait for an adaptor till friday now before i really test it... thankyou for the push appreciated.
 
You're quite welcome, the only dumb question is the one you don't ask lol. That fcb comes with a well drawn easy to read pinout sheet, you're lucky.

There have been times where I've had to scour the internet looking for diagrams and come up empty handed and have to ask too so don't be shy. These forums have all the answers you just have to ask sometimes.
 
Back
Top