Newb here, bought RTF QAV 250 knock off, update firmware and settings - no flying

RENOV8R said:
Did you have the stick all the way forward (full throttle) before you plugged the battery in? When you plug it in, your ESCs should talk to you (not necessarily 3 chimes, depends on the ESCs). Now quickly move your stick all the way down. They should talk again.

Also, this will help with your board orientation. Please note part way down where it says you have to reset the settings whenever you change your firmware - which you did.
http://blog.sam-thompson.info/how-to-change-the-orientation-of-your-cc3d-flight-controller/
Click to expand...
I turned the RC control stick all the way up and I plug the battery of the quad, I get 3 chimes and I pulled the throttle to low position and I did not hear anything or see any change. I disconnected the battery and reconnected and armed but no change in the way it behaves.

Smokey
 
Review the board orientation link I sent you. If the board is spun around 180 degree and not accounted for by changing the settings in Openpilot, what your quad is doing is exactly what will happen
 
Renov8R takes it all by himself to winning circle. Yes my QUAD was flipped 180, I changed as per instructions and changed idling speed for all props and it is flying like before atleast. Check the video of it flying now
Thank you , thank you, thank you

Smokey
 
You must log in or register to reply here.
Back
Top