New build

G

Glenn Fevreau

kracka
Hi guys just after a bit of info please. Have a FrSKY taranis X9D and a FrSKY Delta-8 receiver that i am going to use on a Tarot Iron Man 650 quadcopter.
Can you please tell me what would be all the other components to build a good pic and movie copter.
And yes Im new.
 
Thanks Jackson but as a new builder I've been through nearly every you tube clip I can find and that's why the request for help. Too many variations for motors, esc's, controllers and so on.
Just want to build something that will carry a good gimbal with go pro, FPV setup and a really good controller.
 
lol @Jackson

If I was building a 650 right now I would order the below parts. Keep in mind that it will take some work to keep the props out of view while keeping the gimbal steady.

Do your homework on these parts to figure out what is going to work best for you.

Motors and escs (All 3 of these are very good quality)
1. DJI E600 propulsion system with 12 inch props(plenty of power - best value)
2. DJI E800 propulsion system with 13 inch props(more power)
3. DJI E1200 propulsion system with 17 inch props - arms extended to 330mm ( A LOT of power, and very efficient)

Gimbal
1. Tarot T4-3D
2. DJI H4-3D (if I went with the A3 fc)

Flight Controller
1. Tarot ZYX-M(very stable with lots of functionality, and very low cost)
2. DJI A3 (I would probably go with this since I have not flown it yet)

Battery
6s 5000mah - 10000mah ( high sierra - probably 6000mah on the 650)

500mm x 10mm carbon fiber tubes for the gimbal

Here is one of my builds with some of these parts so you can see the stability

Here is the same build with the DJI A2 and H3-3d gimbal

Here is someone else's build with 17 inch props. (looks pretty sweet!)

Hope this helps get you started ;)
 
Back
Top