RyMar Quad
New Member
Hey everyone,
This is my first flying machine. When it comes to R/C, I've only have had a Traxxas truck, Plug and Play. Now I have put together an X qaud with parts from hobbyking, NAZA M v2 w/ GPS/Compass, 4 SBEC 6A Turnigy 45A ESC's, 4 Multistar 480kv's motors and a Fly Sky fs-th9x TX/Rx. all powered from a 6 cell 5AH battery on an aluminum frame. Downloaded and used the up-to-date DJI assist software and calibrated the sticks, turned one of my switches to go between Failsafe and manual. I've looked at every video I could on Youtube about these components and everything should be hooked up just like everyone else's functioning setups. The problem is nothing seems to work right. I only have to signal wires from the ESC's to the naza and GPS/Compass unplugged. Now I'm at the point where I'll power on transmitter and then plug in the battery for the quad. It starts out in safe mode and gives me the continues yellow blinking, when I switch over to manual, its blinking red as for error. I get error 29 when I plug it via usb to the computer. This is were my brain fries and I am lost. Where am I falling short?
This is my first flying machine. When it comes to R/C, I've only have had a Traxxas truck, Plug and Play. Now I have put together an X qaud with parts from hobbyking, NAZA M v2 w/ GPS/Compass, 4 SBEC 6A Turnigy 45A ESC's, 4 Multistar 480kv's motors and a Fly Sky fs-th9x TX/Rx. all powered from a 6 cell 5AH battery on an aluminum frame. Downloaded and used the up-to-date DJI assist software and calibrated the sticks, turned one of my switches to go between Failsafe and manual. I've looked at every video I could on Youtube about these components and everything should be hooked up just like everyone else's functioning setups. The problem is nothing seems to work right. I only have to signal wires from the ESC's to the naza and GPS/Compass unplugged. Now I'm at the point where I'll power on transmitter and then plug in the battery for the quad. It starts out in safe mode and gives me the continues yellow blinking, when I switch over to manual, its blinking red as for error. I get error 29 when I plug it via usb to the computer. This is were my brain fries and I am lost. Where am I falling short?
