need help with fc

J

jredvr25

Member
so i have a Tarot ZYX-M and i cant make it spin up the motors here is the vid any help would be nice i think i may have to send this back if i cant get it to work been messing with it for 3 days now
 
Check the settings in the software. There is one channel that is the reverse from what it looks like. (It slides the way the control moves so it looks correct) I think this may be your issue, and not allowing you to arm.
 
I think this is what Ringalong was talking about, found this on another site: Make sure that the flight sticks are going in the right direction, some guys had to reverse throttle channel, some had to reverse elevator and throttle channels
If the Tarot is in Failsafe mode it will not arm so double check flight mode switch that it is not in Failsafe! Also, motors will not arm if USB is connected. And not to bring you down, but the ZYX-M is notorious for being DOA. Hope you just have a minor problem and not a dud.
 
OMFG THANKS SOOOOOOOOOOOOOOOOOOOO MUCH yes the elevator was reversed being a noob i didnt notice. 3 Fing days and a bit of stress later thanks again was getting vary unhappy. maybey i can get it off the ground tomorrow
 
No THANK YOOOOOO SO MUCH. I've got a ZYX-M ready to install in my 580 build (just waiting for motors) and you may have just saved me 3 days of cursing and swearing. hahaha. Glad you got it sorted out, interested to hear how your first flight goes!
 
Back
Top