Hello everyone,
I am hoping someone can help me or point me in the right direction for a new build problem I am having.
I have everything assembled and functioning with one small hiccup. The T-Motor F7 stack I have will not produce
any voltage on the FC (on the VTX pads). I have the Pit mode pads soldered along with Battery Voltage pads so that the
vtx will recieve the ~14v from my 4s battery. I also have betaflight setup to activate pit mode via my remote switch and it
flags it as working properly.
As of right now, I have the positive lead from the vtx soldered directly to the Vbatt tab (14v) on the FC and it works good but I have
no way of shutting it down to reduce overheating. Am I missing something? I found this post below but dont really know if
this might help. In this thread, someone had a similar setup and was recommended to try this.
Go to CLI..Type "resource PINIO 1 C14"..Hit enter..Type "set PINIO_BOX = 39,0,0,0"..Hit enter..Type "save" but I have no clue what this even does.
Here is my partial build list
F7 FC + F55a Pro II
Fatshark Avatar goggles with walksnail camera and Vtx.
4s batteries
As of right now VTX is soldered to VTX-Batt which is bridged with middle pad (If I solder onto VTX + nothing happens.
I've tested with a multimeter also. Although the VTX Battery has 14v on at all times.
Pit mode is on, bridged with center pad
Controller setup with Pit mode on, on/off channel, beta flight shows trigger.
Any help is greatly appreciated.
Thank you,
Anthony
I am hoping someone can help me or point me in the right direction for a new build problem I am having.
I have everything assembled and functioning with one small hiccup. The T-Motor F7 stack I have will not produce
any voltage on the FC (on the VTX pads). I have the Pit mode pads soldered along with Battery Voltage pads so that the
vtx will recieve the ~14v from my 4s battery. I also have betaflight setup to activate pit mode via my remote switch and it
flags it as working properly.
As of right now, I have the positive lead from the vtx soldered directly to the Vbatt tab (14v) on the FC and it works good but I have
no way of shutting it down to reduce overheating. Am I missing something? I found this post below but dont really know if
this might help. In this thread, someone had a similar setup and was recommended to try this.
Go to CLI..Type "resource PINIO 1 C14"..Hit enter..Type "set PINIO_BOX = 39,0,0,0"..Hit enter..Type "save" but I have no clue what this even does.
Here is my partial build list
F7 FC + F55a Pro II
Fatshark Avatar goggles with walksnail camera and Vtx.
4s batteries
As of right now VTX is soldered to VTX-Batt which is bridged with middle pad (If I solder onto VTX + nothing happens.
I've tested with a multimeter also. Although the VTX Battery has 14v on at all times.
Pit mode is on, bridged with center pad
Controller setup with Pit mode on, on/off channel, beta flight shows trigger.
Any help is greatly appreciated.
Thank you,
Anthony
