Naze 32 and X8R telemetry

M

Maloose19

Member
Hey guys, I have been pulling my hair out trying to work out how to set up the telemetry on my Taranis X9D from the Naze 32 via the X8R Rx.

I have connected the Rx to the FC using an SBUS CPPM converter and have also gotten my hands on the FrSky voltage sensor which comes with some very basic instructions.

Has anyone had any luck setting up the telemetry using this setup?

Cheers
 
The voltage should come through to your Taranis with the sensor. It should show on the top of screen from what I can recall. You can set the screen up to show how you want to see it. Once armed hold down the page button until the voltage screen shows. You can also have it mapped to a switch and speak the voltage that way you can here the lowest voltage of a single cell in the pack without removing your goggles. Thats how I have mine setup.

Is this one you are using?
http://www.ebay.com/itm/331179905010?_trksid=p2060353.m2749.l2649&ssPageName=STRK:MEBIDX:IT



You will want to run the D4R-II with the Naz32. Smaller footprint, and reports back the voltage that the board reads so no extra voltage meter. :)
 
I am unfamiliar with that sensor. The link above is what I use on my non Naze32 models for cell monitoring.

This guy is using the same one you have.

 
Back
Top