Motors not spinning up, KISS fc

R

Rareden

Member
Greetings, Ive swapped out my old cc3d FC for the kiss fc but ive been unable to get it going, ive wired it all up, in the kiss gui once i arm it i can see the levels for the motors but doing a test does nothing and the escs wont beep or do anything if i plug the lipo in normally. using 12a esc's
Ive tried 3 different firmware versions on the flydunio site with no affect and tried all the esc modes in the kiss gui.
 
Optos from what I can tell.

They are not acting like they are getting power when you plug the battery in? (no beeping or sounds)
 
not really sure how to, the escs only have 3 wires, 1 for signal then + and -, dont know how i can power the receiver if i plug the lipo directly into the esc and the signal into the receiver
 
Power them on with full throttle, and then quickly throttle down. Make sure there are no props on the motors. This should calibrate them.
 
cant get it to do anything, no beeps. think im just going to ditch these escs and order some newer ones, the escs are quite old, may not work with the kiss fc
 
I would think it would be the flight controller before the escs. It is not likely that all 4 escs went bad at the same time.
 
You must log in or register to reply here.
Back
Top