Motors not responding

M

MAFA-27

Member
Hey , I am running my first build with a QAV 250 and a Naze-32 afroflight flight controller.I have a problem that when I move my throttle on my transmitter(Graupner mz-12) it has no effect on the motors.However when I connect my Quadcopter to base flight the throttle/yaw/pitch bars move accordingly.Do I have to configure any settings on the transmitter or on the flight controller.

Any Suggestions
Thanks
 

Attachments

  • IMG_7326.JPG
    IMG_7326.JPG
    284.4 KB · Views: 3
ringolong said:
The green light means it is armed. Have you calibrated the escs?
Click to expand...
Oh Ok , Yes I did calibrate the ESC's , the motors spin on base flight when I adjust the sliders.

Say on a normal transmitter is their any settings one has to adjust to fly a Quad or default would do.For example if I only bind the transmitter and receiver and set the model as an aircraft - would the motors respond to throttle input.
 
MAFA-27 said:
Im really new to Quadcopters , How do you arm the Quad , But every time I move the two sticks on the transmitter to the bottom a green LED on the Naze-32 blinks.
Click to expand...

If you are asking how to arm the quad, I am pretty sure that is what you are missing. The default Naze32/baseflight arming procedure is to hold the throttle stick down and to the right while turning on your RC transmitter.

Some pictures of your setup might help also.
 
Jonny said:
The default Naze32/baseflight arming procedure is to hold the throttle stick down and to the right
Click to expand...
You can also assign a switch.

5DconLd.png
 
The green light means that it is armed. Did you calibrate your radio, and make sure the channels are properly mapped?
 
Jonny said:
If you are asking how to arm the quad, I am pretty sure that is what you are missing. The default Naze32/baseflight arming procedure is to hold the throttle stick down and to the right while turning on your RC transmitter.

Some pictures of your setup might help also.
Click to expand...
Heres a picture and theres one on my first questionIMG_7336.JPGIMG_7337.JPG
 
ringolong said:
If the throttle, aileron, elevation, and roll all move correctly then your channels are mapped correctly. The light does look blue in your pics.

Click to expand...
Ohh ok Ill watch the video and follow along , Yea when I on the Quad a Blue light constantly stays lit , its only when I move both the sticks to the bottom left - the LED flashes green

Thanks - really appreciate it
 
You must log in or register to reply here.
Back
Top