MHQ2 build but i cant figure it out im very new

Ok, here is what I found:


It has a PWM input for the receiver, here is the source of that info.
Try wiring it with PWM, Pin 1 for ground, pin 3 for power in, and the channels as the schematic shows.
upload_2015-11-17_23-51-23.png
upload_2015-11-18_0-7-3.png
 
Last edited:
So I'm going to buy the new receiver? If I do, what else might I need? More cables, like a break out cable? Just anything that might help, I don't even have a beeper or anything. Should I get the OSD that gives me that stuff?
 
Hey G. All the orange sbus Rx's except the 12 channel are on backorder. May have to buy a Spectrum if you need it soon.
 
The schematic makes me really think it is PWM, but the developer/designer wanted CPPM. The documentation is confusing hahaha. I am pretty sure it looks to be PWN, you just connect one ground and one 5v+, the rest are signal.
 
Hey, @Dylan McQueen do you have any way to join a video chat through google hangouts? A smartphone would be ideal, also if you are able, make sure you have a multimeter. I'd like to have you do a quick continuity test of some things that would identify the board's pins with the schematic's pinout. Being as there is a channel for each pin I am almost sure this is PWM (yes I have jumped on this, but did not know that there were 10 pins, and your receiver is PWM). If you could test a few things I could get back to you with a wiring diagram and maybe even walk you through getting it all soldered and wired together.
 
Dylan McQueen said:
Yeah I can do that, it'll just have to be tomorrow after I get off work!
Click to expand...
You are only an hour behind me so any time between 3:30pm and 1:00am your time should be fine with me. Just message me when you are ready, or reply here and I'll post the link.
 
How are you powering it? ESCs with BECs? Try to get a revision 5. Seems to be some quirks with 6.
 
You must log in or register to reply here.
Back
Top