KK2 1.5 Setup help please

R

RcMark

Active Member
I have the KK2 1.5 flight controller and the flysky Tx & Rx, My question is how do I link the 2 together, iv tried putting the wires in order on the Rx 1 to 6 but that doesnt work, any help please?
 
Well that is correct, the KK2 and the Flysky RX have the same numbering scheme. Is the quad fully assembled? Does the RX appear to be properly bound?
 
Well the kk2 gets power from the m1 connector.
You must bind the receiver and the transmitter together first. To get them talking. What exactly is the problem.
 
Hi mate Rav is spot on ,what you can do is take the esc wire from motor one and plug in to the throttle pins on the receiver ( no props on the quad please) power up the quad the receiver light will flash fast this is bind mode Now turn on the transmitter in bind mode make sure your min of 6 feet away when you bind , the light on the receiver should stop flashing when bound
Now power off plug esc back in to motor 1 pins on the FCB wire up receiver to FCB and away you go it should now work
 
Back
Top