Iflight cinebee 75hd unresponsive to TX (x9d)

O

Osamanazir

New Member
Hi everyone! Hope u r in good health and enjoying fpv hobby to its fullest.i got into fpv after watching YouTube videos of various fpv pilots and got inspired by this amazing hobby.

MY GEAR:
Taranis x9d plus
Iflight Cinebee 75HD
Aomway commander v1s
Geprc gep mark2 (on its way).

Yesterday I took out my Cinebee for a maiden flight bound it to the TX (x9d) solid green light but as soon as I push the throttle there is no response.the motors do not spin.i have check the FC by connecting it to betaflight and there everything is working.i inserted an SD card to check the camera and it's also working fine.the only problem is that the drone is unresponsive to the transmitter. Am I missing something or is there something wrong with my setting or do I have to assign an arm/disarm switch before my flight.

Please help me guys.i am new to the hobby and don't know much about troubleshooting.

Thanks.
 
the transmitter responds to the quad when plugged in to betaflight.but when i try to start the drone.nothing happens.the bind led on thrle RX (xm+) is solid green.
 
Have you gone through the Betaflight setup, enabling the correct UART for receiver in the ports tab, assigned the proper serial provider (sbus) in the configuration tab, set up proper switches for flight modes and arming in modes tab and your radio? Can you please post screen shots of your Betaflight ports, configuration and modes tabs.
 
Back
Top