Help with connecting naze32 to receiver

W

wombat126

New Member
Hi guys, new to building quadcopters and this forum!
I'm currently trying to connect my naze32 rev6 to FSR6B receiver, however I cant seem to get it working. If i plug my esc directly to the receiver then I get the melody playing, which im guessing its working, and I can throttle the motors. However if I try to connect esc to my naze32 and then from naze32 to receiver, then it doesnt work.
Ive searched everywhere online but I cant seem to find a manual on how to use the FSR6B, what the channels are, and what pins I connect from naze32 to the receiver. Any help is appreciated!
 

Attachments

  • rsz_2untitled.jpg
    rsz_2untitled.jpg
    184.1 KB · Views: 5
Now plug the other end of the cable coming from the naze into the 6 signal pins on rx aswell as power & ground.
Should be a 3 pin servo. Which is power, ground & signal 1 so there should be another 5 or more. Just cut off the remaining 2 when all plugged in.
 
mozquito1 said:
Now plug the other end of the cable coming from the naze into the 6 signal pins on rx aswell as power & ground.
Should be a 3 pin servo. Which is power, ground & signal 1 so there should be another 5 or more. Just cut off the remaining 2 when all plugged in.
Click to expand...

Hi thanks for the reply!
I did that too, i plugged in pins 1-6 into channel 1-6 respectively, still no luck. Do you by any chance know which pin numbers i should connect to which channels? Cheers
 
Black&red Into first 3 which is battery.
Then signal wires off naze to corresponding numbers on rx. Pin 1 to pin 1 etc etc.
 
On your picture the connection with 8 wires. You don't need the last 2.
The auxiliary channels are 5 & 6
Are you mode 2 Tx?
If so E A T R
 
Hi i fixed it! Turns out it in cleanflight i was using ppm for receiver and oneshot for motor. Had to change them to PWM. Thanks for your help! :)
 
Aileron to pin 1
Elevon to pin 2
Throttle to pin 3
Rudder to pin 4
Aux 5 to pin 5
Aux 6 to pin 6
I have my arm switch on SWD
And modes on SWC (3 position)
You will have to set the Aux switches on the menu on the Tx. Most likely they will be on VRA & VRB. The 2 nobs in middle of Tx.
 
You must log in or register to reply here.
Back
Top