Help! Problem with my V262

[eliasferrazc]

After a very soft crash, my transmitter won't connect with the quadcopter. I thinke ther might be an issue with the board, because i changed the motors a couple weeks ago so i know they are working properly, what else can it be? Here's a link to the youtube video where i explain my issue. Thanks in advance for your time!

 

[Jackson]

I would guess the crash is the symptom not the cause. I can't see very well cuz of the jiggling camera, but look hard for the antenna on the board. There is usually a fine coated wire wire that's about 30mm long that is only connected on one end. Can you see one? Maybe during your repairs it was weakened then fell off.

Example.

 

[lexx]

Yeah hes right I cant see the antenna wire either I have 2 of these on the MK1 and Mk2 board the antenna is normally connected to the tiny upright board attached to the main board . It points sraight up. The little board it is attached to is also one of the gyro sensor boards or accelerometers not sure which but the quadcopter will only arm when it is stationary and level. If this baord is damaged it will not arm take off the legs in your video and put it on a table and see if it will arm. If it does it means the legs may be allowing to much movement on arming. If it does not post a photo of your flight board and i will try to spot any other problems that may cause it.

 

[lexx]

Here is a photo i modified circle is where antenna is attached and arrow is the antenna. Yours seems to be missin g.