HELP PLZ, Aurora 9x, AFRO Naze 32.

A

arky

New Member
Hi all, hope someone can help i have >

Scorpion sky strider
TX Aurora 9x afhss
RX Maxima afhss 9ch
Afro naze 32
Scorpion motor set
Castle 25 esc set
4s opti power 1800mha packs

Not wanting to run a camra atm so just looking to set it up and fly, ive not built one before had loads of helis over the years, just looking for a hack
smile.gif


Im finding it hard to get info on how to conect the rx to the naze and transmiter setup, i have the naze working with clearflight and the motors and esc etc.

Bit concernd the rx might not be compatable with the naze ? I havnt tried connecting it yet as one of the esc was doa so waiting for the replacment
frown.gif


Can anyone who has played with the above etc help ? Thxs jason
 
Last edited:
Well I can't tell if your RX supports PPM, do you know? If not did you get a breakout cable with your Naze32?
 
Hi i dont think it dose support ppm but ive just read the Frsky RX will bind and work so that might be a good option.

I did get a few cables one with an odd connector looks like a two rows of 5 pins if i remember. With lots of single wire servo plugs and one with all three wires.

Jason
 
You must log in or register to reply here.
Back
Top