Help needed please.

K

KGB69

New Member
Hello all members
My name is Kevin.
I am a totally new to Rc Drones But used to fly 60 size Helicopters and scale.
I am having some problems with my build my Acro Naze 32 is not powering up my fs-X6B receiver.
I have done the bind and all went well. When plugged into Cleanflight and Battery or Battery only its not lighting the LED as no power ? everything is set to PPM so only have Ground and positive and pin 1 on the board.
Any advice welcome
 
Did you make sure that the pin you connected to on the Naze was supplying 5 volts? What ESCs are you using and how are they connected? A photo of your connections would be helpful
 
RENOV8R said:
Did you make sure that the pin you connected to on the Naze was supplying 5 volts? What ESCs are you using and how are they connected? A photo of your connections would be helpful
Click to expand...
Thank you for your time .yes I have a 5 volt output running it on pins 6. and used that output to bind transmitter to receiver. Will pop a picture on 2moz, not sure on ESC`s but have had all four working.
 
You must log in or register to reply here.
Back
Top