Happymodel Larva X battery issue

W

waffle3113

Member
So I crashed my drone about 10 feet it fell to the floor. I took it on another flight after the crash and the camera didint have as clear of footage. the antenna was plugged in properly. Then when I land that flight and put a new battery in i'm getting a BATT<FULL and Land now flashing in my goggles. ( drone powers one for like 30 seconds then all the leds on the receiver and flight controller start flashing rapidly. Did I accidentally break something or just accidentally change a setting. What could be broken?
 
waffle3113 said:
So I crashed my drone about 10 feet it fell to the floor. I took it on another flight after the crash and the camera didint have as clear of footage. the antenna was plugged in properly. Then when I land that flight and put a new battery in i'm getting a BATT<FULL and Land now flashing in my goggles. ( drone powers one for like 30 seconds then all the leds on the receiver and flight controller start flashing rapidly. Did I accidentally break something or just accidentally change a setting. What could be broken?
Click to expand...
any luck? i have the same issue. cant get batt < full off the screen
 
You
lmorrissey1 said:
any luck? i have the same issue. cant get batt < full off the screen
Click to expand...
You should be able to control everything that shows up in osd using betaflight configurator to change the osd settings and leave everything else as is. It's possible the quad thinks it's a 3S if using 2S HV batteries so think you can change the expected voltage per cell and warnings as well in the configurator power tab.
 
Back
Top