First proper flight with gimbal, advice please if possible

hipplew

hipplew

Member
Hi all well this is my first flight with a cheap eBay gimbal im pretty pleased with the results so far as the camera is only a clone of a sj4000 as well but my problem comes about 30 seconds in when I tilt the quad to the left it kicks the camera, now I now this will have something to do with the settings but not to sure how to set it up better. Its on a F450 with Emax 2213 10x4.5 props, Naza lite (upgraded firmware) and 2200mah and the gimbal was £28 and had a BGC 3.1 board
Role PID settings are P 7 I 0.15 D 12
Pitch are P 7 I 0.1 D7

Role power is 110 and pitch is 80


any thoughts are more than welcome

Howard
 
Hi mate the gimbal fcb is looking for a signal from the transmitter as you have the naza lite run 2 leads from the gimbal out on the FCB to the gimbal also turn on gimbal mode in the Naza assist
I must say your wife is not impressed dont worry thats normal for a wife lol
 
Thanks for the reply I have put one lead to the naze and to the pitch (to control) it. but you say to put one to the roll as well?? as for the wife hmmm I know it just cost me when she decides to go out spending I try and keep things cheep well she just does the opposite
 
Hi mate just try on the one lead I only have the pitch lead on mine and it did do what yours did till I fitted this lead
 
thanks for the advice hopefully the fog and mist will lift tomorrow so I can try good old Burnley weather lol
 
Jump in your boat and come south its been lovely and sunny today and again tomorrow
 
You must log in or register to reply here.
Back
Top