First Build Problems

Ok so now all channels are working right , so power up transmitter put to full throttle , then hold buttons 1 and 4 on the KK while they are held down power the quad get some one to help , once the battery is plugged in still keep buttons held down there will be a bleep then lower the throttle stick till it bleeps again NOW you can let buttons go , Now go into menu find acc calibration , make sure the quad is 100% level as this will tell the quad were level is
 
Ok now we can test the motors NO props still nearly done now power up transmitter then quad , arm the motors now was you throttle very slowly you need all the motors to start at the same time if not go into misc setting in the menu, there is a min throttle setting its normally 10 turn it up till all the motors start the same time
 
Let me know how it goes all should be good now , the HK firmware is not the best ,if you dont like how it flies we will have to flash with steveis1.8s1pro this is really nice to fly on
 
Okay I was able to test the quad today(it was raining yesterday), but it seems to do the same thing. What number should i get on full throttle in the receiver test im only getting a 74, is the low?
 
Hi you want about 90 this leaves 10 for the quad to use to adjust to level , check the end points in the transmitter you may not be getting full throttle
I just checked if you plug in to a PC there is an end point setting
 
When you calibrated the KK did all sensors come back as OK , if yes try this put throttle trim to zero and calibrate the ESCs again this may then give you more throttle as for flipping , I think we will have to flash the KK with better soft ware , have a look at the KK monitor again and see if any thing has changed some cheapo transmitters are bad for gimbal control
 
Hi looking at props it look like the rear left is wrong ,this motor spins ccw if it is then prop is wrong
Well it looks like back 2 props are wrong
 
Its hard to see on the video as it spins up , you need to check each motor and prop , so front left is cw and the rounded edge of the prop as you look down on it will turn cw , if you can post pics of props I can tell you if they are cw or ccw props and what motor to put them on also a video of the quad with motors just turning i can see if they are right
 
Just looking at the prop they are on wrong , they are backwards to how they should be , have you got skype on your pc so we can video chat
 
the props are on wrong swap front 2 over keep them the same way up but put left on right motor and right on left motor
The back left look upside down
are you in the uk
 
ok a switched the ones on the front and flipped the on the back left, but it made it worse. This time it flipped violently into the ground always on the front
 
Back
Top