RENOV8R
Well-Known Member
Hope someone can help me out as this is new to me, but should be pretty simple. Doing a micro build and I've got the F3 Evo brushed board
http://www.banggood.com/Micro-32bit...-EVO-Brush-For-Micro-FPV-Frame-p-1070068.html
and this tiny receiver
http://us.banggood.com/Wholesale-Warehouse-2_4G-5CH-DSM2-Full-Range-Receiver-wp-Usa-1004179.html
If you scroll down on the description of the F3, you'll see the pin layout diagram. Question is, to connect the receiver, I've got 2 options. DSM pads on the board from pin 3 on the receiver. Or UART 2 (for PPM) from pin 2 on the receiver. I guess I'm getting confused with - is the receiver spectrum satellite that needs to go to dsm on the board, or regular receiver that's just DSM compatible. Any advice would be much appreciated.
http://www.banggood.com/Micro-32bit...-EVO-Brush-For-Micro-FPV-Frame-p-1070068.html
and this tiny receiver
http://us.banggood.com/Wholesale-Warehouse-2_4G-5CH-DSM2-Full-Range-Receiver-wp-Usa-1004179.html
If you scroll down on the description of the F3, you'll see the pin layout diagram. Question is, to connect the receiver, I've got 2 options. DSM pads on the board from pin 3 on the receiver. Or UART 2 (for PPM) from pin 2 on the receiver. I guess I'm getting confused with - is the receiver spectrum satellite that needs to go to dsm on the board, or regular receiver that's just DSM compatible. Any advice would be much appreciated.
