DJI F450 and Turnigy 9X

I

IndianMessi

Well-Known Member
Hello everybody and thank you for taking the time to look at this post.

I finished my F450 build and I am using a Turnigy 9X. The problem is I have no idea what settings to use or where to connect each servo connector, etc. If this helps I am using a Naza-M Lite FCB.

Thanks for your time!
-IndianMessi
 
Your need to go into Naza assist and set up the FCB ( full set up ) this is so you know all all set right ready to fly , would be a shame to crash it on its maiden flight
 
Hi after a fruitful maiden flight I have heard about Gains. I don't know what these are but I do know that they can make a quad fly much more differently. What gains should I use as a beginner?
 
Hi mate its not what gains for a beginner, you have P&I gains on all axis but most link pitch and roll, Ok write down what the gains are right now ,so if you mess up you can put then back in , Put the I gain to zero on pitch or roll if linked it does not matter , adjust up the P gain till quad wobbles very fast your hear the motors twitter now lower till it stop its wobble ,Thats the P gain done
Now do the I gain turn it up till the quad starts to wobble ( but slowly this time) now turn down till this stops , Thats the I gain done
The quad should fly really well now if the axis is not linked then put the same setting on both axis as the one you adjusted but like I said most are linked any way
here is a video for the kk( i know you dont have this board but this will show you what your looking for )
 
You must log in or register to reply here.
Back
Top