Diaton f5 how to and where to connect tyg-ia6c receiver?
- Thread starter Chogs33
- Start date
Launchpad
Well-Known Member
Hard to say without more Flight Controller info.
I would connect to Betaflight and see if any of the UARTs are already set up for serial RC. If so, connect sbus signal to corresponding RX pad on FC. If not, pick a UART that isn't being used & solder to that RX. Lastly set up RX protocol in BF config page.
I would connect to Betaflight and see if any of the UARTs are already set up for serial RC. If so, connect sbus signal to corresponding RX pad on FC. If not, pick a UART that isn't being used & solder to that RX. Lastly set up RX protocol in BF config page.