CT6 no instructions on reciever pinout or binding

cajundood

cajundood

Member
building my 1st low-budget q450 quad and i ordered a fly sky ct6 ratio with the FS-R6B receiver. item arrived but has no instructions whatsoever on binding the transmitter to the receiver or channel pinout diagram. i have a CC3D board and do not want to hook up the wrong channel. From what I've been reading you connect the bind plug to the power on the receiver.....???? If thats the case how do you power the reciever in ordr to bind it? any help on this would be greatly appreciated.
 
cajundood said:
a fly sky ct6 ratio with the FS-R6B
Click to expand...
Usually when you buy a set they are already bound. Did you get the whole package?

20100817160735751_1.jpg


Go to page 16-18 for the bind procedure, but do read the whole thing.

http://www.valuehobby.com/media/wysiwyg/upload/Manual/FS-CT6 Manual.pdf
 
CC3D will adjust to inputs during the Setup Transmitter Wizard. If you want to be technically correct this is the proper mapping.

FS_i6_CC3_D.jpg


Using the pic you often see.

CC3_D_harn.jpg
 
ok....so according to the diagram, the #1 power wire connects to channel 3 on the receiver?? and nothing connects to the power pins?

shouldn't the #1 power wire connect to the power pins on the receiver?
 
Last edited:
Back
Top