Connecting receiver to transmitter

G

Godsyn

New Member
hello! I’m very new to FPV quads and what not. But I can not seem to be able to bind my transmitter to my receiver since I do not have a binding cable and can’t seem to find out how to make one. This is just one of the many problems I’ll need assistance on :(

I have a TaranisQ X7 transmitter and a FrSky X4R receiver
 
10cm piece of wire strip a cm off each end then wrap it around the 2 pins.
Put Tx in bind mode & apply power to the rx. The tx should then confirm this. Unpower & take the wire off.
Or if yo have a servo plug just remove the middle wire & join the outer 2 together.
That's all a bind plug is.
 
If you didn't get one then u probably don't need it. Sorry I don't use frsky gear but that's my MO.
 
Soz if I had the time I would have dug but today is my birthday & I'm @a funeral.
Such is life. I had an inkling the FRSKY didn't need a bind plug. Oh well another drink I think ;).
 
You must log in or register to reply here.
Back
Top