CL_RACING F4S WITH XSR PROBLEM please help

P

PAPPA55

Member
I just built my first FPV drone with CL_RACING F4S AND FRSKY XSR. And my controller is not working. I included what I have done below. After doing all this, when I move my throttle etc, nothing is being received by headlight. Please help. The only thing I seem to come up with is the data being inverted. But not sure.


(Wired)

SBUS From XSR to SBUS on CL_Racing F4s FC


Smarport from XSR to TELE on CL_Racing F4s FC


(PORTS)

UART1 set serial RX on

UART3 set Telemetry output to Smartport


(Betaflight)

In CONFIGURATION

set RECEIVER MODE to Serial Based Receiver

Set Serial Receiver Provider to SBUS


(Receiver)

Channel map set to FrSky


Please help
 
for your UART 3 Smartport, try going into the CLI and enter the command " set tlm_halfduplex = off" Don't forget to save
 
How do you save after command. It just says save to file. Do you just type save and enter. Sorry I am still learning. Thanks Dean.
 
Last edited:
Is Tx bound to Rx. What firmware is the taranis running. I use flysky but the xsr should work fine along with most rx for that radio.
 
I am flying. Misspelled. Gotta love when you phone changes words.
I feel like an idiot. It was the joysticks not calibrated after updating
 
Back
Top